How To Build A Close Board Fence On A Slope

However in order to avoid gaps underneath the panels your fence may need to be custom cut.

How to build a close board fence on a slope.

As this fence is on a drive rather than in contact with the earth the change in level at the bottom of the fence is accommodated by cutting each board at an angle at the bottom in line with the slope in the land leaving a slight gap to allow moisture to run off the fence to avoid rot. The step method leaves a gap at the foot of the panels which you need to fill. The result is very neat crisp and professional. When building a fence on uneven terrain one option is to follow the contours of your yard.

This will leave gaps between the bottom of the pickets and the ground. The particular method you choose may depend on the degree of the slope. Learning how to build a fence on a slope is something you cannot do on your own. The backer rails are perpendicular to the pickets and remain level rather than parallel to the slope.

One of the features of using feather boards is that it is not necessary to step the fence if this is prefered as you would have to with any panelled fence find out more about fencing with fence panels here it is possible to fix the rails parallel to the slope of the ground keeping the post and the feather boards vertical. This is true whether you are using vinyl wood or aluminum fencing on the property. One of those challenges will be the contour of the land. There are a lot of elements that need to be addressed.

Start at the end of the slope and work up. The step method is so named because the fence mimics a set of stairs. The contoured method works best when the slope is slight rather than dramatic. Using a level to make it horizontal.

3 ways to install a fence on a slope. If you are situated in a hilly area and need to build a fence around your yard there are certain methods that should be used to make the installation successful. Method 1 the step method. Through this video i.

If you re constructing a slat and rail fence or picket attach one end of the bottom rail at that mark and extend the rail to the next post. Below is an example of a badly installed stepped fence panel run where the steps have not been measured resulting in gaps underneath the fence uneven gradients and posts that finish below or unnecessarily high above the top of the panel. In order to measure the slope and build the fence you may need the things like level tape measure string line chalk line work gloves post hole auger hand saw power saw hammer chisel nails and screws hatchet hammer the kind of fencing material that you are using and concrete. Erect each post in line with the previous one and attach the panel.

Stepped close board fencing on a slope.