How To Change Oil On Pressure Washer

8 steps to change power washer water pump oil.

How to change oil on pressure washer.

Doing a tune up on our honda 6 5 gx 200 pressure washer by changing the oil in the water pump engine. Use an air compressor or a clean towel to clean around the oil fill area. Loosen and remove pump oil reservoir top access bolt to relieve pressure inside. Warm up the pressure washer s engine by letting it run for a minute so that the oil will flow more freely.

Locate the spark plug wire and disconnect it from the spark plug. Prepare an oil pan or tray to catch the oil. Layer the area with old newspaper or cardboard to catch drips. It has a honda engine but they won t help me either.

Troy bilt won t help saying the model is produced by another company using the troy bilt name. The operator manual says nothing. I d settle for knowing how much oil it takes. Place a drain pan or other container under the oil drain plug.

Briggs and stratton pressure washer oil change. For my first diy project i am completing an oil change on my briggs and stratton 675 series pressure washer for this i required oil catch pan https amzn. Remove the cap and be ready for the oil to spill out at different angles as the cap is removed. Place oil catch under pump s oil drain bolt and grab correct size wrench.

To change the pump oil place the bucket or pan you used for the engine oil under the pressure washer pump oil drain plug. Also changing the spark plugs and cleaning the air. Can anyone tell me where i can down load instructions on how to change the oil in a troy bilt pressure washer model 020296. Empty the fuel tank by running the pressure washer.

You should also change the oil away from any surfaces which may become damaged from an oil spill. Make sure they are far apart from each other to a point where they cannot come in contact. This container will catch the expelled oil. Loosen and remove pump oil reservoir drain bolt and let oil spill into catch container.

Replace the drain plug.