How To Clean And Seal Brick Floors

Leave the baking powder in the area for 15 20 minutes.

How to clean and seal brick floors.

If it s still sealed properly it should. Microfiber mops hold up much better than sponge mops on the rough surfaces of brick floors. Borax is a strong alkaline when undiluted so use only a small amount on your brick floors. Submerge the scrub brush in the soapy mixture and begin to clean your floor.

A microfiber mop might work better for cleaning than a sponge mop. This way you can avoid damaging the surface. You can also use a solution to 1 part vinegar to 15 parts water. Remember that any stains left on the floor will get sealed in with the brick.

I only use a weak vinegar water solution for cleaning floors 1 part vinegar to 15 parts water or more. Rub the cleaning solution into the brick flooring with a scrub. Fill your bucket halfway with hot water and add enough soap for a moderately soapy lather. Remove all the dirt on the bricks and pay attention to the mortar especially if it s discolored.

Then mop the floor with clean water again. You can use a fairly mild solution of either borax or washing soda 1 tbsp. Before you can add any sealant to your brick flooring you must clean it thoroughly. Combine two tablespoons of baking soda in a gallon of water mix well to dissolve the powder fully.

Apply extra pressure on hard to clean areas. Fully dissolve two tablespoons of borax in a gallon of water. Mop the floor using a vigorous back and forth motion to remove stuck grease dirt or stains. The biggest thing is to keep the rinse water as clean as possible so that you re not just depositing dirt back onto your floor.

Pick a string mop or a scrub brush mop since other types may not hold up as well when used on such a rough surface. Dunk a mop into the cleaning solution and wring it out completely so that it is no more than slightly damp. For outdoor brick flooring you can spray cleaning solutions off with a hose. Of the powder to a gallon of warm water.