How To Clean My Fiberglass Shower Floor

Fiberglass however is vulnerable to scratches from tough abrasive cleaning tools and cleaning solutions.

How to clean my fiberglass shower floor.

For tough stains like soap scum spread a paste of water and baking soda over the stain and let it sit for a few hours before rinsing with warm water. There is nothing you can do to avoid this because it comes from using your shower. To clean with baking soda on your shower floor you can use it one of two ways. Fiberglass is easy to clean if you don t get too behind with it.

Having sprayed the fiberglass shower floor with vinegar you may also sprinkle some baking soda on its surface. To clean a fiberglass shower floor scrub it gently with a few drops of dish soap squeezed onto a sponge. Mix some with warm water in a spray bottle then sprinkle it over your steamy shower walls. These ingredients are also included in the best homemade toilet bowl cleaner and for cleaning surfaces in the kitchen.

You can then run the shower again to moisten the mess then wipe off all the gunk. Vinegar works especially well for a rain shower head or even a regular shower head. To clean a fiberglass shower start by rinsing away any loose dirt and debris to ensure that the cleaning solution will work directly on the stuck on grime. If you have a fiberglass shower that has a textured non slip floor you probably know how hard it is to keep it clean.

Apply the paste onto the shower floor and use a scrub brush or a cleaning tooth brush to scrub the paste into the textured grooves. Drying the floor can help reduce the time mold and mildew has to grow. Baking soda works well to clean a fiberglass shower floor because it not only absorbs odors but is a very mild abrasive that will remove soap scum and grime without scratching the fiberglass surface. Fiberglass shower floors usually have soap and other residues on them.

For any tough deposits apply a thick layer of baking soda on an old toothbrush to scrub them off. Afterwards rinse with warm water and dry with a soft cloth. Clean your showers at least once a week to help keep soap scum and mildew at bay. The baking soda and vinegar will combine to make a foamy liquid which can be brushed onto the floor with the help of a sponge.

Next spray the shower and tub surfaces with a solution made from cup of liquid dish soap and 1 cup of white vinegar that s been heated for 1 minute in the microwave. You can also try drying the floor of your shower with your towel after you use it. Soap scum and mineral deposits from the water build up in the indentations and are almost impossible to remove. Fiberglass is a popular material for showers because it is cheap and is relatively simple to install.

Avoid this by properly cleaning fiberglass and seal it to prevent stains from soaking deep. Baking soda water make a baking soda paste with water and baking soda. This is a problem i fought for years.