How To Cut A Ceramic Rod

I need to cut a ceramic rod down to replace a broken shaft in a sedra 5000 impeller.

How to cut a ceramic rod.

Do you think the bare eye would have an adverse effect on the integrity of braid. Draw the cut line where you want to sever your ceramic pot using a wax pencil. Hold the tile in place and mark the area that has to be removed. The ceramic line guide insert on my brand spanking new rod came out before i had a chance to string line through it.

More ceramics rod property more ceramic rod process. Ortech offer ceramic rod in stocked and custom lengths. The sizes of these rods range from 0 011 to 1 350 in alumina and zirconia ceramic. Place foam rubber or a folded cloth between the jaws of the clamp and the pot to keep the clamp from breaking the pot.

With the height of the blade set to 1 above the surface of the sled insert the dowel from the long end and stop it at the edge. Our ceramic rods are multi size multi type and have a wide range of applications. The braid line is tuff line supercast. Step 2 place the ceramic pot on a work surface and use a clamp to secure it in place.

But i would. We manufacture and sell high quality high precision ceramic rods. You can mark the hole a little larger then needed if you have a large decorative plate that will cover the hole. Make sure the edge of the slot is aligned properly with the side of the blade then clamp it to the table saw sled on the long end.

01 14 2010 08 57 pm 2. I wrote airrus and asked for a new insert. 0 393 to 21 654 10mm 550mm length diameter as small as 0 2mm can be customizations. 2 652 i ve never done it.

Here is one way to doing it.