How To Do You Cut Laminate Flooring Around Cabinets

Work through the edges planks against the cabinet sides.

How to do you cut laminate flooring around cabinets.

Measure the space you have between the last laminate plank and the cabinet. Install a new floor and shoemold. This may take a few attempts to get the exact shape you want the laminate to be. This will give you one side of hole exactly fit half way around the pipe.

Hold a piece of paper around the pillar or pipes and trace around the objects. As soon as the blade reaches maximum speed push the guard against the cabinet and lower the blade into the flooring. In earlier days the only solutions for removal that this wonderful power tool provides was either removal of cabinets or painstaking hammering and chiseling to remove the underlayment. A good example of this is a door frame where you obviously can t go around the whole frame with the edging as the door would never close so you cut away the bottom section and the laminate sits underneath.

How to cut laminate flooring the easy way. Some of the kitchen elements may need to be undercut or cut tight to avoid having shoemold like the partitions at the ends and around the refrigerator. Cut out the paper pattern and then lay it back down to test for accuracy. Grip both handles of the saw and push the start button.

Draw it slowly along. Make a paper pattern to help you make curved cuts and avoid wasting laminate flooring. The other side of the piece you cut will be too small because the saw blade. Next you saw the laminate into two pieces with one edge of the saw blade aligned through the dead center of the hole you cut.

Make sure the pieces are laid firmly without gaps and bumps up to the point where it meets the cabinet edge. Usually when you have an area that does not lend itself to having the standard edging trim you need to cut away the offending section and slide the laminate underneath. Put a straight edge down between the marks at each end of the flooring plank and draw a line between the marks. Then you drill a hole through the laminate the diameter of the pipe.

Then cut exactly that length of flooring so it will fit in. If the floor trim is too long for the cabinets cut it to size with the circular saw.