How To Drill Through Ceramic Pot

Set your pot upside down so that you are drilling from the outside in.

How to drill through ceramic pot.

Wear your safety glasses as there s always a chance the tile will split sending ceramic shards into the air. Pop your masonry drill bit on to your drill and secure it in place. Make sure you add eye protection too you don t want to mess with flying shrapnel. Increase the drill speed while maintaining the same position on the pot.

I flipped my pot upside down and placed the tip of the drill bit in the center of the pot. Just because not all of the most aesthetic pots have drainage holes doesn t mean you can t use them. Put the tip of the power drill in the center of the masking tape. Here are some great articles that teach you how to drill holes in plastic clay and ceramic pots.

Use a nail to make a puncture mark in the exact location on your ceramic pot where you intend to drill. How to drill a hole in a ceramic pot step 1. Set the carbide tipped masonry bit in the drill. 5 16 3 8 and 1 2 diamond drill bits for ceramic glass check the package just to make sure it s ok for ceramic.

Ceramic container place the flower pot upside down on a hard flat surface like cement or a deck. Some of them specifically say not to use it on certain materials even if it drills through tile painter s tape. If you do not have a nail you could use a marker pen to highlight the target. Turn the drill to a low setting and begin drilling the tile at a steady pace using even pressure.

Center your drill bit so that your hole will be in the center. Be sure that the pot is set somewhere where it is secure and won t move as you start to drill. Get the cooling water set up. How to punch drainage holes in plastic flower pots and how to drill drainage holes in ceramic flower pots and planters.

How to drill a hole in a ceramic pot. Spray bottle of water. Then we applied moderate pressure while drilling down into the ceramic pot with a slow to moderate speed. Step 4 drill the hole.

Before drilling you may want to place some newspaper or cardboard under the flower pot to protect the work surface. Lay the bit at a low angle where you want the edge of the hole to be located.