How To Drill Through Hard Ceramic Tile

Work slowly as this will help prevent the tile from cracking.

How to drill through hard ceramic tile.

To make it easier the diy video even listed the tools and drill bits used in the tutorial. Drill through the tile slowly. Drilling holes in wall tiles is a fairly easy skill to master once you know how. Ceramic tile can be drilled with a carbide bit while glass and porcelain call for a diamond tipped bit.

How to drill through porcelain tiles. Have the right bit for ceramic tile. It will drill any type of tile. The big difference is the drill bit.

Standard drill bits don t work on tile but not to worry. The strength of ceramic tiles makes it difficult to drill a hole in it. There is actually an easy foolproof way to drill a hole in a ceramic tile. It might be tempting fire up your drill and go hell for leather to break through the glaze but this is a sure fire way to overheat the drill bit and create vibrations that will most likely crack and ruin the tile.

Apply moderate even pressure to the drill so the bit grinds away at the glaze or the tile. Learning how to drill through porcelain tiles is pretty much the same as learning how to drill through ceramic tiles. How to drill a hole in a ceramic tile. If not done properly you will end up with a cracked tile or one that has many scratches on it.

Set the drill to a slow speed on normal setting. It s a must that you use diamond tipped drill bits for porcelain. When in doubt buy the diamond bit. If you re on your own and can t hold the drill bit in one hand the wood pattern in the other and cool the drill bit at the same time then you can stop from time to time and spray some water on it.

Use a small wet sponge to cool down the drill bit and prevent it from overheating. Set your drill to the lowest speed and apply modest pressure to the surface. The lowest tile drill bit speed possible say 100 or 200 revolutions per minute is perfect to drill standard ceramic tile. Load the diamond drill bit into your corded or cordless drill.

This may take three or four minutes. Layout the wall for success. If you drill fast you ll overheat the drill bit and ruin it.