To dry beneath wood floors which have been flooded first you should remove any wet floor coverings such as rugs or carpet.
How to dry out a wooden wet floor diy.
Use fans to circulate the air in your home and have patience as your floors dry.
Then rinse the wood surface and dry once more.
Clean with clean water in a bucket.
The only sure fire way to assist drying out your wood floor in a timely manner is to remove a plank piece segment area of the floor and or edge and from there you can get access underneath.
The effect wet rot has on a property can range from the manageable a squishy chipboard floor to major loss of structural integrity of important structural timbers if you feel your wet rot problem is something you can tackle alone here are some tips for diy wet rot treatment.
Do that by scrubbing it with detergent water and a little bleach.
The problem is how to dry wet floorboards which extend under other flooring.
Then place a dehumidifier at high settings to pull out any moisture that is still in the air.
Scrub the entire floor and all related woodwork baseboards stairs and newel posts etc with a stiff brush rinsing the brush frequently in the bucket.
Mix a mild detergent and a compatible disinfectant such as mr.
Gently rub the stained area until the haze is gone.
However you may run into things such as if the wood was glued down and running into damaging board s once you get a plank off.
If the water leak is localized in one area make sure to isolate that area by either closing the door or blocking off the doorway with a plastic tarp.
This causes wood to expand and retain that moisture but this can be dried out of it rather quickly.
Five things you should do to dry out wet wood in your house are remove standing water expose the wood circulate air add heat and run a dehumidifier.
The first step is to absorb any water lurking on the surface of the floor.
Wood that is wet from applied water can still last for a while so long as you dry it out as quickly as possible.
Treating wet rot yourself.
When wood has been wet for an extended period you ll also have to clean mold.
Then you have applied water which is when the wood is left out in the rain and water soaks into the wood fibers.
Once you have removed the dirt and debris clean up the leftover water with the wet vacuum and apply a wood floor cleaner to remove the leftover disinfectant.
Next dry the floors completely by pumping out standing water then mop and towel the surface dry.
Completely dry the wood.