How To Empty A Dyson Ball Vacuum

Do not use any detergent or polish on any part of the machine.

How to empty a dyson ball vacuum.

As well as acting as a pivot point to help you steer your vacuum the tonka yellow ball actually contains the motor assembly and in so doing lowers the center of gravity of the vacuum cleaner itself. To clean the brush bar of your dyson vacuum turn your vacuum upside down and remove the cover using a flat nose screwdriver. Clip accessories onto the vacuum s tool holster so you ve always got them to hand. The clear bin can be wiped with a damp cloth.

However it is not as difficult as people think. Press the button near the rectangular inlet to separate the clear bin from the cyclone. Microfiber is a good material to use as it s positively charged. Pay attention and follow the steps below.

It is normally underneath the cyclones. Then you may want to take a damp cloth for cleaning the inside of the dust canister. Check the nozzle connection inside the dust bin compartment and clear any blockages before returning the dust bin to position. How to clean a dyson vacuum.

Firstly you have to empty the canister of any debris. Rinse under a cold tap until the water runs clear you don t need any detergents. Push the catch on top of the dust bin to release it from the dyson vacuum. The dyson ball vacuum is almost half the size of the companies previous model and it weighs less to boot.

Be sure to shake it vigorously to get out as much dirt as possible. Grip the handle that sits atop the dust bin and press the catch button to release it from the vacuum. Push the button on top of the dust bin while holding it over a waste bin to empty the bin. Press the button on the dust canister to release the base and empty debris into the trash.

Next wipe out the remaining dust inside the brush bar s compartment and the brush bar with a damp microfiber cloth. I bought this about 2 years ago and my wife mentioned it was not working as well as it had. Pull the bin out separating it from the vacuum. Press the button again to open the bin base.

Turn off the dyson ball and unplug it. Then remove the hair and other dirt that is tangles around the roller with a pair of scissors. Check the bin and cyclone for blockages and remove as necessary. People still think that cleaning a dyson vacuum is very complicated and takes a lot of time.