How To Even Out Wood Floors

Applying polyurethane in even coats is a crucial though not always simple task.

How to even out wood floors.

Typically two to three coats are used with sanding in between coats to even them out. Every wood floor poses its own challenges but installing one can be even more difficult if the subfloor has peaks and valleys. Sand lightly with 220 grit paper. Still be sure to test out the polish in a small hidden or inconspicuous location on the wood before tackling the entire floor.

The easiest way to find out if your floor is out of plane is to use the time honored marble method. Watch our step by step video showing how to level a wooden floor with expert advice and top tips to help you complete the job with confidence. A plywood subfloor will bridge any minor waves in the existing floor and leveling compound would help too. In that case knowing how to properly flatten a subfloor before the flooring installation is essential.

This compound can potentially be utilized on a concrete slab or a wood subfloor and it works well when you are dealing with dips in the floor. Put a 36 grit sanding disk on a floor edger and sand the edges of the floor. On the top side of the floor another fix it idea to lay down new hardwood over the existing floor. Once the compound is dry make another sweep with your electric sander to shave down slight differences in the height of the subfloor and even out rough patches.

Vacuum the floor when you re done. The key is to apply a thin base coat to partially seal the wood before wood staining. This job is a good example. When you are dealing with uneven floors one option that you have is to use self leveling compound.

Mark the baster with a permanent marker. Sand from one end of the room to the other pushing the sander along in a straight line and reversing your direction each time you reach the opposite wall. Scrape the finish from corners and under cabinets with a pull scraper. Sand the entire floor.

Drop a few marbles onto the floor in various areas around the room and then watch them roll. Clear and clean your wood floors of dust and dirt. Let it dry for a few hours. You will have to make sure your joists can handle the addition of considerably more weight from the plywood subfloor and any floor coverings.

Draw out equal amounts of sealer and solvent to make a 50 percent solution.