How To Extend Old Floor Light To Led

Be sure to pay close attention to the arrows located on plug there is one small arrow molded into the plug on the light side of the cable and one small arrow molded into the plug on the driver side of the cable.

How to extend old floor light to led.

Or run a fused spur from a socket outlet. If you ll be controlling the lights with the pull chain you may want to lengthen the short piece dangling from the light. Run a spur from an existing junction box or from a new junction box. If you re still teetering on the fence between led and incandescent here are seven things you need to know before switching to led lighting.

You could run a spur from the last ceiling rose in a loop in circuit. Peel the top layer off to expose the ends. Installing floodlights can enhance the security and appearance of your home. Depending on where you want to install your floodlights you may be better off hiring an electrician to do the work.

Now simply hang your lights from the nails or hooks you installed. There are various ways of extending a lighting circuit to add lighting points. If you used your own wire for extending the distance between the driver and the light cut off the aspectled supplied connector on the light and driver and strip the black and red wires then connect to your extension wire being careful to keep the polarity consistent. Making the switch to leds is easier than you think to get the benefits of led without replacing all your existing fixtures all you need to do is replace all your incandescent screw in lightbulbs with screw in led bulbs.

Use a sharp knife to make a slit along the black lines between the light and the end of the led strip. Hang led shop lights. How to install flood lights. Just snap on the extension chain provided with the light before you hang it from the ceiling.

There is understandably a lot of confusion about light bulbs these days. Place a connector in the other side of the clip so the strip can lay flush along the corners.