How To Finish A Rough Concrete Floor

Fill the damaged areas with epoxy resin to the surface level of the surrounding concrete floor.

How to finish a rough concrete floor.

How this is done will vary depending on the finish to be applied. Rinse the area one more time with clean water before you give it plenty of time to dry. Press it down so it fills all the small holes in the concrete. Typically if you are beginning with a raw concrete floor you will need to fill in any holes or cracks with an expanding epoxy.

Keep adding mortar until it makes a small rounded mound on over the concrete surface. Finishing a raw concrete floor generally means grinding it down to a smooth level surface and then polishing it with a series of increasingly fine abrasives until it achieves a lustrous sheen. Diluted coffee brown acid stain sealed with acrylic sealer in order to steer clear of intense surface preparation ken used concrete overlay on this highly exposed concrete floor project before applying the acid stain. Prep work and cleaning.

Acid stain over smooth gray concrete overlay. For carpeting over concrete use a carpet pad to protect the carpet and make the floor a little softer. Step 1 spray down the completely cured driveway thoroughly with a high pressure garden hose or pressure washer. For instance you can t clean the surface with muriatic acid if you re planning on using an acid based stain and cracks or holes may need to be repaired for some finishes but can be left as is for others.

When finishing your concrete driveway a grinder can be used to roughen the surface to make it safer. Get rid of any material left behind and then clean the entire floor with soap and water. Use a trowel or your hands and fill the space with mortar. Step 5 determine the solution.

Allow the floor to dry before adding a second coat of paint. How to finish concrete floors. Scoop the mortar into the crack or hole. Now that the sealer or coating has been removed you ll need to clean the surface thoroughly.

Use tape to create the design of your choice on the concrete floor. For existing surfaces most projects will consist of three phases. Use a putty knife to fill the crack or hole in the concrete and then level the top of the resin with the floor using the knife. Dragging of broom on the fresh concrete surfaces creates small ridges that provide for traction control and slip resistant.