Align them over the pre drilled holes in the centre of the tracks and screw them on.
How to instal sliding door track.
Let s get started on our diy barn door track installation walkthrough.
Install the bump stops in the centre and at the end of the tracks to stop the doors rolling too far in either direction.
Previous step next step.
Anchor your mounting board the first step to making sure your barn door track system is properly installed is to ensure the track is securely mounted to the wall.
To install sliding closet doors start by screwing the top track into position at the top of your door with the track facing down.
All doors are made to fit a standard opening height of 2260mm.
Install the bump stops in the centre and at the end of the tracks to stop the doors rolling too far in either direction.
Install the centre bump stops.
Tilt the door into the opening with the bottom side going in first using shims as necessary to create a secure fit.
There are several different materials that are used to manufacture sliding door guides.
Begin positioning the door into the opening from your exterior area.
Follow these steps for a quick and easy installation project.
When installing a new sliding closet door or repairing a damaged one you may have to add or change the door guides that keep the door in place.
Step 1 choose guide materials.
Next screw the bottom track into place or glue it down if your floor is made of concrete.
Installing the wardrobe sliding door tracks identify and if necessary construct the correct opening width for your doors using the table below.
Align them over the pre drilled holes in the centre of the tracks and screw them on.
Use joint brackets to attach sections of track as needed.
Place shims around the edges and top of your door frame every 12 inches.
The tracks should be exactly as long as the section along which you wish the door to slide.