How To Install Cabinet Hardware Template

They are also available at any home center.

How to install cabinet hardware template.

Leah demonstrates how to create a template for installing perfect cabinet door pulls and knobs using a cabinet hardware jig link to the kreg cabinet hardwar. I make a template and show how to accurately mount cabinet hardware. Hold the template so that the stops are tight against the side and bottom of the cabinet door. Use cabinet door hardware template.

A template makes the job go faster increases uniformity and reduces the chance for mistakes across the cabinet set. Step 7 hold the drill level and drill through the appropriate holes on the cabinet hardware template and then attach the hardware. To create the template. Step 6 line up your cabinet hardware template along the edge of cabinet.

Mark your hardware templates. They ll save you so much time and stress. Use your drill to drill through the cabinet door at the hole location in your template. Start by determining where exactly you want your knobs to sit.

A cabinet hardware jig shop our easy to use option here is a plastic template that has pre measured holes offering easy correct placement for your cabinet hardware. Cut a small piece of thin wood or even a piece of cardboard or cardstock would work. The edges of the square you cut will line up with the edges of the cabinet doors. Traditional solid brass screws used to mount hardware on the face of your cabinet.

Having a template will allow you to do your measuring once and then simply line it up and mark your holes. Once you ve built the cabinet hardware template you can easily use it to drill all the holes for the new cabinet hardware. Either hold it steadily in place or use a bit of painter s tape to secure. If you have more than a few knobs or pulls to install use a template when you install cabinet hardware.

The hardware templates are the real heroes of this project so if you re hesitating to spend the 10 on them they are completely worth it. Here s what you ll need. I ve installed my share of hardware and i find the best way to go about getting it right is to make a template.