How To Install Door Contact Sensor

To install your door or window sensor follow these simple steps.

How to install door contact sensor.

The place where you should install a sensor contact on a door is on the stationary frame. Open and close the door several times to make sure the door doesn t make contact with the sensor on the frame and shift its position. For door held open alarms if you overlay contact sensor data with access data and see that there was a door opening event contact sensor log that doesn t correspond with an unlock event access log then that indicates that the door was forced open without a proper unlock. How do i and where should i fit the magnetic door or window alarm contact onto my doors or windows.

If you re installing additional sensors it s easy to add them using the getsafe smartphone app. Then mount the magnet on the moving part of the door as close to the sensor as possible. Find a place on the door or window that is out of reach of children and pets. Identify the alignment markings on the contact the markings need to line up to close the circuit 3.

If you have a home or building which is already pre wired for an alarm installation then without a lot of potentially messy work you are stuck with the position of the cables for the installation of the magnetic contacts onto your doors or windows but hopefully the installer has positioned. Most door contacts function using a sensor and a magnet. Most door contacts need to be within a half inch of the magnet when the door is closed for proper operation. If your closed window or door doesn t match up with the frame or moulding you can offset mount the contact sensor and magnet.

Shop on amazon if you d like to support this channel https amzn to 2dpjpltamazon stubby door window contacts like the ones in the video. Remove 2 black screws 2 silver screws pull speaker cable up vertically and away from circuit board not across the circuit board pull the 2 cables from the female white sockets next to silver screw socket that holds speak. The sensors included in your starterkit are already paired with your smarthub. Just make sure that the two pieces are less than 1 inch apart and you see the led blink and hear the chime when you open the door or window.

I d be interested in how other people have done this. Clearly the sensor is designed for doors that fit flush with the frame but anyone in the uk with a upvc door will know that the door overlaps the frame and there is a lip of around 1 5cm. So if you have the sensor mounted on the door it will not be in contact with the magnet.