How To Install Door Panel Clips

You will likely have to give the door panel a couple medium sized palm slaps around the perimeter to seat all clips.

How to install door panel clips.

This results in some annoying squeaks and rattles from the panel not being able to snug closely to the door. When you have done this repeat for the other hole and you can then install your panel onto the clips. Twist the very end of the rivet off of the gun and then place your clip over it. The door panel on your vehicle protects the window and lock mechanisms inside while offering an attractive finish for your interior.

The old door panels i am replacing were not original so i could not use them as a guide. The top of the clip attaches to the door panel then the base gets pushed into special openings in the door. Northclad recommends doing a panel mock up by marking the film on the edge of the panel at locations coinciding with building framing members then attaching the panel clips to the panel extrusion at these markings. Door panel clips get torn up pretty badly if the panel was ever taken off after ford originally put them on.

If you ever have to take the panel off for some reason i e. You need to use your screwdriver to install the panel clip using a knurled screw to hold the clip against the rivet. Am i supposed to remove the pre cut material completely to install the clips. Once the panel clips are attached the panel is ready to install.

If your door panel is not finished at the top because the door has a chrome lip or wood trim like this jag it will need clips secured along the edge once the panel is in place. Recently took off my door panel to reupholster and found a quick way to instert your new door clips. What keeps that panel in place are door panel clips. Installing new oem door panels but they did not come with instructions.

This should give your panel a tight grip on the door. Finally line up your door panel s clips with all holes in your door and use your palm to force the door panel into place.