How To Install Door Sweep On Storm Door

How to weatherstrip your windows.

How to install door sweep on storm door.

The first thing to do is open the door to reveal its edge here on the side on the base of the door you should see a plastic or rubber cap at its base this is your storm door sweep. The bottom of the door will need to be measured in order to determine the length you will need. Step 1 open the door to 45 degrees. If the sweep is stuck open the door grab the underside with both hands and pull up as if you were trying to lift the door.

Wrap around or l type door bottoms or sweeps. That will break the sweep free. The spacing of the kerfs vary and you will want to match profiles. Using your heavy duty tin snips or a hack saw cut the door sweep to fit the bottom of the door.

Cut the sweep to fit the door. With the door closed measure the bottom of the door and transfer your marks onto the door sweep. The door sweep may have to be adjusted. Close the door and insert a putty knife between the sweep and door.

Cut new door sweep to length if needed. Most of these types of door bottoms have a single or double kerf cut in the bottom of the door for the sweep to lock into. Slide the door sweep onto the bottom of the door. Snap or push new door sweep onto bottom of door.

Install the door sweep. Kung fu maintenance shows larson storm door latch lock assembly plus sweep install kung fu maintenance video get or price the larson low e clear view storm d. Determine the door sweep length needed. Install or replace a door sweep a door sweep seals gaps between the bottom of the door and the threshold.

Tap on the putty knife to move the sweep down until the fins on the bottom contact the threshold. Most just pry off. Remove the existing door bottom. If a door sweep will be installed on each door they will need to be measured separately since the sizes vary.

With the door closed screw the sweep to the door so that its bottom is in contact with the floor. Most metal storm doors have an adjustable sweep that can slide up or down. Just loosen the screws on the inside of the door raise or lower the sweep and then tighten the screws. You will later cut the door sweep down to the appropriate size.