How To Install Front Door Handle And Lock

Then install the handle set according to the instructions aligning the spindle with the latch.

How to install front door handle and lock.

Next fit the knob on the spindle and tighten its setscrew. Align the strike plate for the handle against the door jamb and attach with two small screws. Watch this step by step video guide from bunnings warehouse and learn how to make sure the handles. The handle will stay in place leaving your hands free to secure the interior trim.

You ll need this to buy a new knob or handle. The spindle holes are where the door handle will eventually be inserted. If you are installing an exterior door choose the handle and lock at the same time. To steady the base of the handle insert a mounting screw and hide its head with the decorative cover supplied.

Add the interior lever rotating the chassis tabs so it slips through the latch and easily joins the handle. When you place your order the manufacturer will drill the necessary holes in the appropriate places. Drill these two spindle holes on both the front and back of the door. Install both knobs by sliding the spindle through the slot in the latch.

Installing a door handle is a relatively easy diy project. Create the spindle holes using a drill being careful to keep the drill parallel with the floor. If you are buying a new door and the holes are not pre drilled use the template provided by the lock manufacturer to ensure holes are drilled correctly. I do have another video which shows how to remove and replace a.

Align the spindle on the back of the assembly with the throughbolt and the slot in the latch. Make sure the bent lip of the strike plate is facing the direction in which the door opens. Fasten both with mounting screws. Fit the lock over the projecting cylinder post and put the knob s spindle and rosette assembly on the thumb latch post.

Follow the template instructions to drill the hole in the right location. This video will specifically show you how to remove and replace your exterior door lock set. To avoid damage to door it may first be worthwhile running a utility knife around edges of plate to break paint seal. Slide the adjustable throughbolt up or down as needed and press the handleset onto the door.

Once the door is drilled installation is a simple job. Unscrew latch and plate from edge of door then pop out latch. Measure backset from edge of door to centre of hole usually 60 or 70mm. Align the two long screws from the inside knob into the cylinders on the exterior door knob and tighten the screws.