Link to blinds used.
How to install vertical door blinds.
These type of blinds no.
To install blinds start by making marks on the wall where you want to hang the blinds either inside the window frame or on the wall above it depending on your preference.
The installation hardware kit is included with most new blinds.
Attach the first vein by gently sliding it up into the plastic stem until it snaps into place.
Make another mark in the second hold.
Vertical blinds allow you to choose total privacy moderate light or uncovered windows with the twist of a wand or tug of a cord.
Hold the first bracket in place place a screw in the first hole and tap with a hammer to make a mark.
The portion of the vertical blind that rotates is called a vein.
Mark holes for the brackets on the inside of the upper frame of the door or window.
Step 3 calculate the height inside the window at the right side middle and left side.
To make it easy to install the veins begin by spacing the vein stems evenly by pulling the cord.
Next open the door on the each mounting bracket and line it up with the mark you made.
If your looking for a window covering for a large window or sliding patio door you ought to consider installing some vertical blinds.
Test your vertical blinds by pulling down on the cord to open or close and blinds.
Https homedepot sjv io m3ybqwas looking for a secure blind option for our exterior patio door which could hold up to pets and kids.
Pull the chain to rotate the openings in the stems so they face you.
Pick a point under the sliding glass door where you want the vertical blinds to reach.
Measure 3 inches 7 6 cm from the side of the frame and 1 inch 2 5 cm out from the glass.
Measure the height of the blinds up to the top of the sliding glass door.
Use the shortest width.
Place the bracket near the outside bottom of the window frame where it will not interfere with the operation of your vertical blinds.
Using a pencil mark the measurement of the height of the blinds.
Install your safety bracket to keep the cord or chain taut.
Then attach the brackets by drilling screws through the holes on the back of the bracket.
Decide where you want.