How To Level A Bathroom Vanity With Legs

Move your vanity as close to the attaching wall as possible.

How to level a bathroom vanity with legs.

Use two or more wobble wedges stacked at each stud where you will attach the vanity to the wall. Add permanent legs to your existing vanity. If you plan to install it over concrete check for excess moisture by gluing down a 3 x. Pre drill holes through the mounting board and shims and then secure the vanity with screws.

With the right preparation and adhesive vinyl flooring can be installed over almost any clean dry surface. You must leveling a bathroom vanity top before attaching it to the wall. When the legs are screwed in fully and tight to the vanity they are very strong and stable. If this be the case cut 1 2 inch off the back legs.

If one of the legs is slightly uneven or if the floor has tilted over the years a shim allows you to hold pieces of furniture like your bathroom vanity level and to use it more easily. This is what you new legs will screw into. A shim is a wedge shaped segment of wood that allows you to hold furniture items level. I m putting in a bathroom vanity and the floor is not level.

While it s pretty simple to do you don t want to add more than 6 or the cabinet will start to look funny. Below are the steps you should follow in order to create a level vanity top. Step 1 move the vanity. However if i were to try to unscrew one even just a little bit to take up some of that floor unlevel the leg gets really wobbly.

We use cookies to give you the best possible experience on our website. The trouble is the legs of this vanity are 6 turned wood legs with a threaded wood screw on the top. I suppose you could put a black toe kick behind the legs to block the dust bunnies. I have to raise the front of the vanity so i can make the answered by a verified plumber.

Then you will have only one front leg off by 1 2 in. If i understand the original post the front legs do not touch the floor when the vanity is leveled. If the floor or wall is not level you will have caps to close with your molding. Your bathroom vanity should sit level on your bathroom floor.

To add legs to your bathroom vanity you will have to add a frame that screws into the base of your vanity. Do not pull it out of place. Sometimes you have a panel toe kick covering the feet after you place the cabinet sometimes you don t. My walls in the bathroom are not straight.

I have a new vanity that is a tradional style with short queen anne style legs. Check for level again before you fully set the screws in place and add more shims as necessary.