How To Light A Pilot Light On A Furnace

Depress the button or knob for about 30 seconds.

How to light a pilot light on a furnace.

This will be a button that s located next to the pilot button on your furnace. Once the gas has had time to dissipate turn the knob to pilot then hold down the reset button and bring the flame of a long lighter close to the pilot light opening. In most cases this knob has three distinct settings. This should light the furnace pilot light.

This should light the furnace pilot light. Once you are sure the pilot light is on release your pressure on the reset button. Turn the gas control to pilot and hold it in while you light the flame with a match or a lighter. You do this by simply holding the lighter up to the pilot opening.

In principle lighting a furnace pilot light is not terribly complicated. Lighting the pilot light on a gas furnace part 1. Once you are sure the pilot light is on release your pressure on the reset button. You will then use a long lighter and light the pilot light.

Once the gas has had time to dissipate turn the knob to pilot then hold down the reset button and bring the flame of a long lighter close to the pilot light opening. Step 1 locate the pilot light assembly and reset switch. If your old gas furnace has a standing pilot you can follow a standard procedure to relight the pilot light. If your furnace uses a pilot flame referred to as a standing pilot in order to light the gas in the burners you may have faced the problem that it has gone out and hence your furnace won t operate.

Pilot off and on if you are unable to locate this assembly or knob refer to the user manual for your furnace and try to locate a diagram that can tell you where the knob or switch is on your specific unit. The pilot light is typically in the bottom of the furnace near a small knob. Turn off the thermostat remove a few panels to locate the pilot light light it a. Light the standing pilot place the lit match or ignited lighter tip at the pilot while depressing and holding the reset button or depressing the knob as appropriate.