Use a roller to apply one coat of paint.
How to paint commercial metal door frames.
Roll brush 2 coats of paint.
This will minimize the brush stroke marks on your door when it is finished.
Metal paint coating metal surfaces.
Most typically you can come in and spray your frames right when the sheetrock gets done and come back the next day with low tack tape and tape them off or sometimes i will mask the frames first and prime and paint the walls.
Let paint dry completely then rehang door.
There are a variety of painting methods manufacturers can use.
Make sure that you are using a paint that is designed for exterior use such as an exterior satin or semi gloss paint.
You can come back and run some paper around the frames to protect from the gloss overspray.
How to paint commercial metal door frames.
Prep up to 2 hr per 100 lf scrape sand and patch up to 4 defects per 100 lf.
Apply multiple thin coats rather than one thick coat.
Apply the first coat of primer and let dry.
All of the components are brought together as an assembly prior to the painting operation.
Paint in tapped holes.
Use a sanding block or an orbital sander to strip the steel.
Consider the handrails staircases pipes metal door frames ceiling joists window frames lamp posts metal fences and garage doors to name just a few metal surfaces that can be found in typical residential or commercial settings.
These holes are in various components such as reinforcements.
Sand with fine grit and finally extra fine grit sandpaper.
Door frame painting labor basic basic labor to paint door frame with favorable site conditions.
Door frames in commercial premises can often take a beating.
In areas of high foot traffic commercial door frames are frequently bumped scraped and knocked.
Apply a finish coat.
Brush paint evenly and lightly brush painted areas with a dry brush to remove streaks and runs.
Over time this additional wear and tear can leave door frames damaged and in need of repair.
Use a brush to carefully paint any grooves or panels on the door before painting the rest with a small roller.
Apply a second coat of primer if necessary apply at least two coats of exterior satin or semi gloss paint.
Both hollow metal doors and frames have various holes that are drilled and tapped.