How To Paint Doors Smooth Finish

Paint a flat door with a brush pad or roller with a 1 4 inch nap or foam sleeve.

How to paint doors smooth finish.

For the first sanding on oak cabinets 100 grit is great for removing the lacquer top coat. Roll within 1 inch of vertical door trim and corners and within 2 inches of the ceiling. Without a smooth base you can t get a smooth finish. This will give the primer good tooth to hold on and create the right base to start with.

Spread the paint and smooth your brush strokes with a foam roller. Paint can dry unevenly and result in a patchy finish. You are using benjamin moore advance paint over a previously painted door this paint can be used over either latex or oil based paint and is awesome for not leaving roller or brush marks so it s my go to paint for trim and doors. You can scratch the fresh primer and paint on cabinet doors very easily using the wrong tools and sandpaper.

Roll the topcoat paint on the primed walls just as you rolled on the primer. Brush paint onto the cabinets. Adding floetrol will help greatly in getting a smooth finish. Let each coat dry and sand it by hand with 220 grit sandpaper before spraying the.

If the door is vertical you should spray several thin coats rather than a few heavy ones to avoid drips and runs. These scratches become noticeable in the final coat of paint. As i ll describe for painting below. Once the surface is sanded smooth it s time to paint.

Priming is ideally done in the same order edges first etc. The texture that rollers impart works well for walls and ceilings but isn t attractive on doors or wood trim. Add a small amount of floetrol affiliate link to help the paint level better. A softer wood like maple should be sanded with finer grit like 120 or 150.

Latex paints can be dry and ready for a. 10 let the first coat of paint. Sand any bare wood to 120 grit and no finer. If you paint a door while it s.

If you use a roller backbrush immediately with a wide brush or pad to smooth the roller stipple. A big factor in getting that factory smooth finish is using good quality paint made for doors and trim like benjamin moore advance or sherwin williams proclassic. Using a 25 paint brush that is designed for the type of paint being used will also go a long way in getting a smooth finish. The smoothness of a paint coverage depends almost as much on the applicator as the paint.