Log in ask question.
How to put front door lock back together.
The handle will stay in place leaving your hands free to secure the interior trim.
How to install a gainsborough hd7 security door lock.
Lock fitted in door material the lock is fitted into the leading edge of the door not the surface of the door 4.
Be sure that the locking mechanism is on the correct side of the door inside the bathroom or bedroom the spindle of the knob will fit through the latch.
For more information on our hd7 range plus downloadable installation instructions.
Once all back together it locks if i do the following.
Open with a key you can open the lock from both sides with a key 3.
2 screws on the inside of the door remove them.
Pull the unscrewed part toward you until it comes off.
Open box with new lock.
Look closely at everything as you do this so you you have an idea of how it goes back together.
Step 1 remove the screws of the deadbolt.
Once the screws have been removed the faceplate can be pulled out.
Remove these screws with a screwdriver.
Un lock the lock.
Sometimes the latch piece is adjustable and you have to select either 2 3 8 or 2 3 4 but the picture you linked is non adjustable and accepts both sizes at once.
5 levers the number of levers should be stamped on the faceplate of lock e g 5 lever.
Generally you can pull it straight out though in some cases you might need to twist the faceplate counterclockwise before.
I need a diagram to put an amerock door lock back together.
The face of your deadlock that is on the inside of your home should have two screws on it.
Removed lock mechanism cleaned oiled and replaced.
Home science math history literature technology health law business all topics random.
Push screwdriver though hole away from you until part of lock on outside of door falls off.
Insert the latch into your door making sure the curved side of the latch faces the door jamb.
As for putting it back together.
I had the same problem.
Slide the adjustable throughbolt up or down as needed and press the handleset onto the door.
The part of the lock that the screws are in is known as the faceplate step 2 pull out the interior faceplate.
A fiddly job as bits fell off it had seen better days.
The latch itself aligns in two ways.
Slide the door knob into the door and through the latch.