How To Relight A Pilot Light Oil Furnace

Press the small button while you press the electric ignition.

How to relight a pilot light oil furnace.

Oil furnaces will heat automatically. Find the gas valve. If you can t find the ignition button check the instruction sticker on your furnace or the the owner s manual. They use a sparkplug when the unit calls for heat the pump starts and simultaneously a sparkplug is energized to ignite the fuel oil.

Lastly set the valve to the on position. Turn the gas control to pilot and hold it in while you light the flame with a match or a lighter. Hold the lighted match to the pilot opening while you push reset on the pilot control panel. Relight the pilot light with the ignition button if your furnace has one.

Do not worry just turn the switch back on. The ignition button will usually will have a small red button next to it. Keep this button depressed until the pilot flame burns brightly. Steps for relighting the furnace pilot light.

Near the valve you will see a reset button. Oil burners do not use a pilot light. Wait to see if the pilot light stays on. Keep the knob in for 20 seconds and then release it and turn it to the on position.

If your old gas furnace has a standing pilot you can follow a standard procedure to relight the pilot light. Now you can switch the valve to the pilot setting. Come fall time or any time your pilot light might go out it is time to re light your pilot light please thoro. This is usually red and should have settings for off on and pilot turn the gas valve to the off setting.

Keep holding the button until the pilot flame burns brightly then release the button. How to light the pilot light to your furnace. There s no sticking a match into the machine to light the oil or a pilot light but if it is not igniting you can check a few things to make sure. Raise the thermostat to verify.

The furnace should start automatically. Once the oil is hot the heat is propelled through the house by way of a furnace fan.