How To Remove A Garage Door Tension Spring

If you encounter resistance and the spring won t budge thoroughly spray the spring and stationary cone with a penetrating oil and allow it to soak for five minutes then try again.

How to remove a garage door tension spring.

This is accomplished by opening the garage door as fully as possible until it hits the stop bolt on the track. Garage door springs have the primary responsibility of maintaining the tension necessary for your garage door to open and close at a controlled speed. Let the spring slowly unwind towards you and then insert the other winding bar in the hole at the top. Disconnect the garage door opener so the door remains closed.

Step 1 unplug the garage door opener and clamp the door to the track. In this article we would explain the function of your garage door spring and the common signs of a broken spring on garage doors. Open the garage door to remove all spring tension and clamp it in place. Take out the bottom one only when the top one is well inserted and held firmly in your hand.

Once in place disconnect the garage door opener. You must release the tension on the garage door springs before attempting adjustment or replacement. What is the role of your garage door spring. Tighten the pipe wrench so it is snug against the spring and slowly apply force to the wrench so that it turns in the direction opposite the winding of the spring.

Continue this procedure until there is no tension at all left in the spring. Repeat the same steps on the second spring if need be. Put on eye. Press the spring into the mouth of the jaws of the wrench with your thumb and rest the other end of the wrench on the top of the door.

Hold the garage door in this position by attaching a c clamp to the track at a point below the lowest door roller wheel. Use locking pliers or a c clamp to secure the door to the track to keep it from opening when you release the tension on the springs 1 x research sourcestep 2 loosen the set screws while holding each spring with a winding bar. Next pull down on the winding cone with a winding bar.