How To Remove Ge Side By Side Refrigerator Door Handles

The bottom hinge is simply a pin in a hole lift the door toward the ceiling half.

How to remove ge side by side refrigerator door handles.

Pss25ngmdww the owners manuel does not give the correct diagrahm for removing the handles from the door. Unscrew the screws and remove them from the handle setting them aside. I have a 2002 ge 25cf. Locate locking tab under the handle at the upper handle base.

Step 2 use a flat head screwdriver to carefully pry away and panels or covers that are over the screws. I refuse to put a bumper pad on my cabinet. I have a brand new kitchen aid side by side counter depth refrigerator krsc503ess. For instructions on replacing the handle.

How can i tighten the handle i ve been through the owner s manua read more. Desiree sometimes the trim can be tight. Turn clockwise to tighten. First remove the end caps at the top and bottom of the door.

The refrigerator side door handle is loose and pulling away from the door. They may be on either the sides or the bottom of the handle depending on the model of refrigerator. Press the locking tab down and pull the handle up and away from door. Kitchen aid was no help.

I have searched everywhere for solutions. If there are no removable panels or covers try sliding the handle upward downward left or right. Even if i am very careful opening them they fall open. Look at the bottom of the freezer handle to locate any screws securing the handle to the bottom of the freezer door.

The doors open so far that the handles bang the cabinet. Side by side refrigerator model no. If you remove these screws the top hinge will be disassembled. You might first have to pop off a plastic cover.

I need to either remove the handles read more. A few ge refrigerator handles are installed on tracks and must be slid off the tracks to reveal the screws holding the assembly to the door. I have a ge side by side refrigerator model gss25wgta 88. I hope this will help you.

If the trim will not slide carefully use a small screwdriver and pry the trim slightly to help get it started. Open the freezer door. Remove the handle and replace the screws. Use a 3 16 inch allen wrench wx05x10316 to tighten the mounting stud.