How To Clean Wooden Block Flooring

Just two ingredients warm water and vinegar give you everything you need to clean and shine your floors.

How to clean wooden block flooring.

Mop the floor in the same manner as you would with plain water. Since parquet floors are patterned by different sizes of wood vacuuming can reach the dirt between the cracks. Do use a professional hardwood floor cleaner to remove occasional scuffs and heel marks just spray some cleaner on a cloth and rub the stained area lightly do use a damp mop. This is because the grain of the blocks will be facing in different directions.

In all the above cases use cloth to dry the flooring afterwards in order to remove excess water and avoid the danger of water stains. For either the vinegar or the cleaning product remember to apply only to a small area at first in order to ensure no major damage should the flooring react badly to the cleaning solution. Do not vacuum if there is no hard floor setting attachment available. Don t use a wet mop or use excessive water to clean your floor wood naturally expands when it s wet and can cause your floor to crack or splinter.

Sweeping is important to get all. Water vinegar and essential oils if you want to add a nice fragrance to your cleaning solution try this combination of vinegar water and essential oil when you re ready to mop. Allow the floor to air dry. Vacuuming is a good first step for clearing your floors.

Then mop the floors using diluted white vinegar diluted lemon juice or a commercial hardwood floor cleaner. Many vacuums have a special setting for bare or hard floors. You can add more or less to the water based on your preference. Certain dry mops even have special tissues especially for wood floors or parquet floors.

Step 1 vacuum the floor. Once you have the floor sanded back to bare wood a final sanding with a fine belt will smooth everything off and then you can apply your chosen finish. The rotating brush on the vacuum will scratch the surface of the floor. For more advice on choosing and applying finishes to wood flooring have a look at our treating wooden floors guide.

Place cup of vinegar in the large mop bucket which now has warm water in it. Next dip your mop into the mop bucket and be sure to wring it thoroughly. Begin by vacuuming the entire floor to remove the majority of dirt dust and sand. You can use a normal brush but you can also use a dust specific dry mop.

Combine cup white vinegar with 1 gallon warm water for cleaning especially dirty parquet floors. To clean hardwood floors start by sweeping them with a soft bristled broom or vacuuming them with the bare floor setting on your vacuum. Steps to clean the floor.