Then push that open end of the string right back through the bottom end of the pulley.
How to repair patio umbrella string.
Open the umbrella and turn it upside down.
Drill a hole all the way thru the pole just under the spokes large enough for the allen wrench to have a little wiggle room to slide in and out.
Buy a 6 piece of 5 8ths copper from your local home improvement store hammer it down flatten it until it can fit over the broken parts of your umbrella rib.
The rope is found stiff the nuts and bolts inside the box completely corroded.
Cut the cord with the scissors and tie it on the umbrella crank with a small knot.
Step 7 insert the knot into the hole and position the crank bolt so you can tighten the nut with the pliers.
Close the umbrella canopy manually by slowly pushing down on the yoke.
Unscrew the nuts knowing you could end up with a broken screw middle up.
Feed it through the same hole where the old string was.
Remove the crank box cover screws.
Repairing a patio umbrella rib is a relatively easy task that can be done at home with only a drill hammer and a couple of nuts and bolts.
Fixing another piece of garbage designed by people who need to get a different job.
Light a match and hold it to the end of the cord to melt the ends so they won t fray.
Tie off the end of the string into a secure double knot.
Turn the crank slowly and carefully to wind the string for the first time and to open the umbrella.
Dismantling the umbrella crank.
Engage the button or slide lever near the handle of your umbrella as if you were going to open it all the way but stop short of letting it lock in the open position.
Thread the end of the string through the hole in the yoke that supports the umbrella canopy.
You ll have a smoother time fixing your umbrella s ribs while there s a little slack in them.
Insert the allen wrench and boom you re done.
Now put your string through the same side your pulley is on.
Tie a knot at the bottom end of it so it won t pass through all the way.