How To Cut Laminate Floor Trim Over Thrus Hole

How do i go about laying the laminate but keeping access to the service hatch.

How to cut laminate floor trim over thrus hole.

To cover up the gap that would occur because of the saw width use 1 4 trim molding or a small threshold. Let go of the blade guard and allow it to snap into place. Fix the strips to the laminate cover all round all square 45 corners from underneath with very short screws and plop in in the hole. Fit the pieces around the pipe and use glue suitable for laminate to attach the pieces together.

This may take a few attempts to get the exact shape you want the laminate to be. Cut the tongues out of the pieces that would cover the door. Hold a piece of paper around the pillar or pipes and trace around the objects. Mark your cut line and cover it in masking tape to protect the laminate.

How to cut laminate countertop diythis is a short video demonstrating how to cut laminate formica countertop without chipping with a circular saw. Mark the dowel where it comes. Stick a strip of masking tape over the countertop widthwise so the mark you made is centered underneath to keep the laminate from chipping during cutting. Use a hole saw about 1 2 in diameter larger than the pipe diameter to create an opening for the pipe.

Find a dowel that will fit the hole. Plunge the saw blade into the laminate flooring. Cut out the paper pattern and then lay it back down to test for accuracy. Sand it a little to taper it smaller towards one end and fit it into the hole.

It s someone elses floor so it needs to be done properly. Use a 1 by 4 inch board or straightedge jig to help you cut a straight line with your circular saw. Measure in from the part you are going to cut off with a measuring tape and draw a line where the cut will go. Or make your own cover using laminate to carpet joining door threshold strips sort of h section.

Lay down the floor and simply cut out the section of floor that covers the door so that the access door has a cover. I m laying a laminate floor in a room which has a service hatch in the floor the flooring is t g chipboard. Sand file the hole in the floor to trim the edges. Make a paper pattern to help you make curved cuts and avoid wasting laminate flooring.

If the floor is levelled as you say there should be very little movement and can be lifted readily. The hatch is roughly 8inch in from an outside door and roughly 12inch from the wall. Set your circular saw depth to 1 4 inch. Cut the laminate piece in half across its width through the center of the hole.