How To Install Deadbolt Door Lock

You can use power tools to make this process simple and fast.

How to install deadbolt door lock.

2 repeat step 1 on the exterior side with the key. Each step in installing your deadbolt will mirror the steps you took to remove the deadbolt. Chisel out any excess material place the strike against the hole trace around it and mark the screw holes. Get the peace of mind you want with this added security.

There should be holes on the top and the bottom of the set plate. Install the deadbolt lock about 44 inches above the bottom of the door. This should seem familiar. After installing the deadbolt lock make sure that you installed it correctly by putting in your key and trying out the lock.

Choose a position on the door for the lock. Now go back to the exterior of your door and simply slide new faceplate s metal piece into center hole. Drill deep enough so the deadbolt can fully extend without interference. 1 with the door open turn the thumbturn to extend and retract the bolt.

Next place the combination square on the edge of the door and draw a horizontal line through the mark and a few inches beyond. It should extend and retract smoothly. 3 now close the door and use the thumbturn to operate the bolt. Insert screws into both to secure the set plate and bolt into place.

Measure six inches above the center of the door handle and mark with a pencil this is where you re going to install a deadbolt lock. Screw the set plate into your door. Place the keyed side on the outside of your door with the thumb latch on the door s inside face. Then use a chisel to create a mortise for the strike.

Installing the faceplate of new deadbolt. You ll have to adjust the position a bit if you have a combination storm door so as not to interfere with the storm doorknob or lock. Drill 1 8 inch pilot holes for the screws. The deadbolt should open and close smoothly.

Learn how to install or update your current deadbolt.