How To Cut Laminate Flooring Around Floor Vents

Start with a hardwood board the spans the vent at least 6 inches on both sides.

How to cut laminate flooring around floor vents.

Use it as a template to determine the size of the hole by tracing around that part of it that penetrates into the floor. Keep the speed square there and mark on the square where the first cut will be and the last cut you can use tape on the square. This may take a few attempts to get the exact shape you want the laminate to be. If it s in the middle of the plank you can drill a hole in a corner to start it.

Remove the tape and you should have a chip free cut line that you can smooth out if necessary by scraping with a utility knife. Mark the edge of the board at the left and right edges of the vent. How do you cut hardwood flooring around a floor heat vent. You can use either a sliding model or a non sliding model just make sure the blade is large enough to cut the entire width of the laminate flooring in one pass.

This is the ideal tool and can cut perfect 90 degree cuts or any other angle up to 50 degrees for most saws. Some of the advantages. Take a speed square and mark on the tape where the cut out length starts and stops. The first thing that you should do is remove the cover from your floor heating vent.

Place your vent in place on the floor where you want to cut the hole. Make a paper pattern to help you make curved cuts and avoid wasting laminate flooring. Fastst most convenient way to cut boards. Note that you want to use the actual inside wall of the vent as the measurement point.

Drill a single hole in one corner to get the jigsaw started then cut through the tape around the entire outline. Place a strip of blue tape on the wall or baseboard at each vent opening. Mark it out on the baord and cut it. Im going to install hardwood flooring but i cant figure out what kind of saw to use to cut the hardwood piece around the floor vent.

Most vents will have a flange that covers a part of the floor. Cover the general area of the cut out with masking tape and draw the outline on the tape. Cut out the paper pattern and then lay it back down to test for accuracy. Hold a piece of paper around the pillar or pipes and trace around the objects.

You should eventually be able to lift the cover completely off.