Take off the top of the vacuum and remove the dry filter.
How to dry out car floor.
Also put your heat on recirulate not outside air.
Allow to run for an hour and.
6 step 2 remove floor mats and hang them in the sun.
Run the heater full blast with the heat coming out the floor vents.
Then the wet carpet issue.
To clean ones carpet floor mats there are some good tips online ranging from taking them to a car wash or scrubbing them with a broom and detergent and leaving them to dry in the sun.
Crack the windows down about an inch.
You should also prop up any floor mats so the air can circulate below them.
If your car is soaked or if there s a lot of standing water you ll want to start by getting that out.
Take out all the carpets and put them in.
To evaporate the rest of the moisture open all the doors and face a fan towards your car to dry it out.
But first make sure you shop vac out any excess water.
Start your truck and put your heat on high and on floor vent.
Use a wet dry vac to remove the excess water.
Perhaps scrub it with laundry detergent rinse out repeat if.
Start by positioning a fan two if possible so that it blows across the car s floors and seats from one side to the other.
Remove the insulation under the carpet and dry in the sun.
You should do this for at least 2 days.
Place the damprid in shallow plastic containers and leave the car sealed up overnight.
Then plug in the vacuum and start sucking up the water 1 x expert source victor belavus air conditioning specialist expert interview.
Step 1 vacuum up lots of water with a wet dry vac.
Remove the seat s and peel back the carpet.
Keep the car s doors open and leave the fans running for at least a day inside your garage.
Just make sure to do this in a secure location like a locked garage so no one tries to steal anything in your car.
The heat will make the water evaporate and the open windows will let the moisture leave the car.
A shop fan is perfect for this.