How To Install Artificial Grass On Paving Slabs

For example a concrete pool deck can be slippery but covering it with synthetic turf can provide a more attractive safer surface around your pool.

How to install artificial grass on paving slabs.

Choose the direction you would like the pile to face. Plus its soft and perfect for those long summers in the garden and those cold winter evenings building a snowman with the family. Leave the grass for a couple of hours to allow it to settle. This is probably one of the easiest bases to work with when it comes to.

Artificial grass is colourful and bright without bringing a coldness to the garden. Tips for installing artificial grass over concrete or asphalt. The process of laying artificial grass on slabs is much simpler and more straightforward than doing so in an area of your garden where there was once a lawn. Stretch it out ensuring it covers the full area as well as leaving a 50mm overlap at each side of the area.

In some cases installing artificial grass over concrete will improve the surface and make it better suited for your intended use. We recommend that you lay your artificial grass with the pile facing towards the house if fitting in the back garden. Carefully roll your artificial grass out across the anticipated area. This would have to involve removing the existing turf adding a base layer of sand levelling the surface and finally adding a membrane layer but when laying artificial grass on slabs you virtually have a clean canvas to work with from the get go.

If the concrete pavers do not form a level surface you need to level off the area by either adding concrete on top of the pavers or it might be to dig them out and prepare a level sand base for your artificial lawn installation. Starting at one end of the concrete and ensuring the foam goes right up to the edge roll out the first piece of foam and cut to the required shape. How easy is artificial grass to install on paving slabs. Depending on your chosen synthetic turf you will find the grass is raised 15 40mm above the surface of the area.

If you re laying artificial grass to replace natural grass start by digging out the turf down to about 100mm using a spade or a turf cutter. It is important to make sure that the area where you want to install your grass is level. How to fit artificial grass to hard surfaces.