How To Empty Clean Water From Rug Doctor

Easy measure solution pour cap onto the tank.

How to empty clean water from rug doctor.

You can either tip it over and pour it out or plug it in and turn on and pull the lever and spray out the bottom or suck it out with a wet dry vacuum you can tie a string around the level to hold. Fill the reservoir of your rug doctor with hot water. Clean water tank holds 1 5 gallons of water. Fill the clean water tank follow the directions on the back of the rug doctor cleaning solution and fill the easy measure solution pour cap with the recommended ounces of solution.

Use the suction hose on the machine and place into the tank of water and suck it out. If debris is present remove the filter screen by pushing it right and compressing the spring until the filter end is clear of the dome. Replace by compressing the spring wire and inserting the black end securely into place in the hole inside the dome. The manufacturer recommends adding 1 2 cup of rug doctor carpet cleaner to the water for the dirtiest carpets or 1 4 cup of carpet cleaner if.

Any remaining fluid will drain out underneath the machine once the water stops running out turn the machine off. Note the machine needs to be plugged into power. Make sure that there is no rancid smell or else this smell will end up in your carpeting and padding.