How To Fix Garage Door Lock

Depending on the model you have you may need to pry it out with a crowbar and hammer or remove it with a drill.

How to fix garage door lock.

Step 2 remove the pin that secures the inside lock handle to the lock shaft in the center of the door panel. Place the vice grips on the door track above any door roller and lock the vice grips on the track. Use the chisel to remove the door stop on top as well. If no holes are present you can drill holes using a hand drill and a metal drill bit.

Garage doors won t open refuse to lock or age and warp. Pry up on it until it comes loose and remove it. Most garage doors have a square knockout that can be removed. The power goes out.

Locate where the ends of the locking bars hit the track and miss the hole. Tap the end of a chisel under the door stop on the striker side of the jamb. Close the garage door and attempt to lock the door from the inside. Loosen the screws that secure the locking bar guides at each end of the door panel with a 3 8 inch socket wrench.

Step 3 loosen the screws that secure the locking bar guides at each end of the door panel with a 3 8 inch socket wrench. Garage door repair is can be costly but these basic tips will keep your garage door running smoothly all year long. Locate where the ends of the locking bars hit the track and miss the hole. The side lock will need to be installed on the garage door using 4 bolts.

Most likely this will resolve the situation. Try replacing the batteries in the remote and trying again. Close the garage door and attempt to lock the door from the inside. If that isn t the problem then try opening and closing the door with the wall switch.

Step 3 install replacement install the new lock according to the manufacturer s instructions. In most cases a homeowner can fix an overhead garage door lock catch in a relatively short time using everyday hand tools 1 close the garage door. Working inside the garage clear away all items. A garage door side lock can be purchased for under 10 dollars.