How To Fix Lid Lock On Whirlpool Cabrio Washer

At that point the lid light makes a clicking noise.

How to fix lid lock on whirlpool cabrio washer.

The actuator shifter and or the lid lock assembly. Place hose ends in a bucket to catch water remaining in the hoses. Sorry on yours do the following. Then connect the red wire to the blue and white wires and wash cycle should begin.

Lower the assembly carefully and let it dangle freely from its wire harness at around chest level. Press the tabs inward and or unfasten the retaining screws using a screwdriver and lift the top panel. Use a 1 4 inch 0 64 cm nut driver to loosen the two mounting screws holding the box in place on the bottom of the panel. 01 door lock motor and switch assembly.

Also check and reset all electrical wiring connections under the washer and behind the control panel. Check both of these parts visually and with a meter if needed. If your whirlpool cabrio washer will fill with water but won t spin the lid lock switch is probably bad. Next open the lid and insert a screwdriver into the lid switch actuator hole.

Remove the lid lock switch assembly. Locate the retaining tabs and or screws that hold the top horizontal panel down. Check for any kinks in inlet hoses which can restrict water flow. I had the lid replaced once under warranty only to have it break again.

Other videos suggest disabling the spring and using epoxy to repair the broken pl. I have a three year old whirlpool cabrio wtw5500xw washer that just stopped running today after two loads. The lid lock clicks the sensing light goes on and i can hear the usual slow half spin when i read more. This video provides step by step instructions for replacing the door lock or lid latch assembly on whirlpool washing machines.

We make fixing things easier. If possible remove the inlet hoses from the back of the washer. This is one of the most common problems with direct drive washing machines. To do this turn the water supply off then use pliers to remove the hoses.

To diagnose this problem you ll want to put the washer in a spin mode. Here are the most common reasons your whirlpool washer door lid won t lock and the parts instructions to fix the problem yourself. The most common reason for rep. Connect the blue and white wires start a load and wait until the lid lock red light comes on.

The 2 parts that can cause the washer not spinning and lid lock light flashing on your whirlpool washer are. Whirlpool washer door or lid won t lock.