A worn strip lets water seep beneath the door and onto your floor.
How to put on a shower door sweep.
Open the shower door from the inside and leave it propped open.
All you need is a pair of scisso.
Buy frameless shower door sweeps from dulles glass mirror.
Trim off its overhanging end with a utility knife.
Haven helping you to show your house some love.
If your floor gets a shower when you take one chances are your shower door sweep the rubberlike strip that lines the bottom of the door needs to be replaced.
The sweep attaches to the inside bottom of the door and has a drip edge to direct water back into the shower and a rubber sweep on the bottom of the door to keep water from splashing out.
Determine which door bottom is needed.
Step 2 carefully grasp the edge of the door sweep pulling it towards the outside of the door until the strip has come loose from the track.
Open the shower door and prepare to remove the existing shower sweep.
With the vinyl sweep pointing down hold the drip rail against the inside bottom edge of the door.
Slide the vinyl sweep back into the groove in the rail.
The snap in door bottoms come in different designs and sometimes even the heights of the door.
Depending on the type of door sweep that is currently in use it may be necessary to unscrew the door sweep from the track.
Crimp the ends of the groove closed with pliers to hold the sweep permanently in place.
Mark how long it needs to be and use cutting pliers to cut to size.
If the sweep is glued down to the base of the shower grab one of the ends of the sweep and firmly pull the sweep away from the door until the entire piece gradually comes loose.
Learn how to replace the water barrier on the bottom of a glass shower door.
Slide on new door sweep.
Snap the sweep onto the bottom of the door and slide into place.
If door sweep fits too loosely a spot of adhesive or caulk may be applied between the sweep and the bottom of the door.
Snap in door bottoms or sweeps.
Measure your new seal against the edge of your shower door.