Apply a wood preservative with a paintbrush.
How to install bottom door seal.
Insert one end of the seal into one end of the door bottom.
Slide the seal fully onto the door bottom.
Seal the bottom of your garage door.
Brush away the dust with a soft bristled brush.
Measure the door at each point.
Make sure that you face the inside of the door as you take this measurement.
Step 3 prepare the door.
Position new door bottom onto bottom of door.
Position it so that the flexible bottom piece of the sweep just grazes the floor.
Cut new door bottom to length if needed.
Open the door then measure the bottom of the door using a tape measure.
How to install a cinch door bottoma step by step video on how to install a door bottom cinch door seal bottom is a fast and easy way to save money by sealin.
Pull out staples with the help of a staple remover.
At the same time the thick part creates a weather resistant barrier.
Install the product according to the instructions given usually with the thin side sliding into each gap.
Apply a generous amount of spray lubricant into the grooves on the aluminum door bottom.
Be careful not to fit the sweep too tightly.
Remove the screws on the existing door bottom.
Apply new screws to hold door bottom in place.
The fastest way to see if your garage door requires a seal is to wait for a sunny day.
Remove the seal and discard.
Sand the bottom of the door with medium grade sandpaper.
Use a nail puller to pull out the nails or screws that secure the old seal to the door.
Unlike the measurements you took for the top and side seals you will need to measure for the bottom seal by measuring the bottom of the door itself.
This will seal the gap underneath the door while also preventing the sweep from dragging against the floor when you open and close the door.
Close door and adjust door bottom as needed to get the proper fit.
How to replace a door sweep or bottom seal is one of the first video s where i did a voice over because the customer was a work a home lady who needed the.