How To Install Bottom Wire On Chain Link Fence

End posts have one hook up.

How to install bottom wire on chain link fence.

Tension wire generally is installed after the poles are set for a new chain link fence and before the fence installation. You ll want to dig your terminal posts first and then install your line posts. Fix the top of the roll every 150mm or 6 inches with tie wire. Once tension wire is stretched walk along fence line and tuck the bottom tension wire under then between the posts and the chain link fabric.

The wire holds the chain link in place low to the ground very tightly so that it cannot bend at the bottom. The wire is positioned between the mesh and the poles. This fitting requires one 5 16 x 1 1 4 standard fence bolt and nut. Place your wire dog approximately ten feet from the terminal post.

The is a little known easy tip to get the bottom tension wire on a chain link fence super tight with very little effort chainlink stretcherhttps. Adding tension wire to a chain link fence provides stability and security from dogs or people who try to go under a fence. When the line wires are tight take the roll of chain link and stand it against one of the end posts. Pull the tension wire taut by hand along the fence line.

Corner posts have two hook ups. Go to inside of fence and secure tension wire to chain link fabric with steel aluminum or vinyl coated hog rings normally every two feet or closer if more strength is needed. To install a chain link fence start by establishing your property lines and placing your post holes 4 inches inside those lines. Wrap the cable end of your come a long around the base of the terminal post above the end band.

Step 4 place one brace band on first to use if bottom tension wire will be installed. Step 3 a hook up is each connection of chain link to an end or corner post. Install the insulators on the chain link fence two about every 10 to 12 feet at the chest and nose level of your dog. Staple every loop to the post after fixing the top of the fence to the line wire.

Place and end band at the base of the terminal post. The electric fence wires should end up 4 1 2 inches to the inside of the physical barrier.