How To Light The Pilot On A Lennox Gas Furnace

This may be behind a metal panel or door with instructions.

How to light the pilot on a lennox gas furnace.

How to light the pilot light to your furnace. Wait at least five minutes as this allows the gas to dissipate and helps to avoid any potential fires. Step by step lighting of pilot on the lennox g12 furnace. When the pilot is burning brightly release the rest button.

This electrical voltage is then used to open the gas valve to allow gas to flow to the burners. Does anyone have experience lighting this type of furnace. Turn the knob to the pilot setting which will re start the flow of gas to the pilot. Come fall time or any time your pilot light might go out it is time to re light your pilot light please thoro.

As previously mentioned the pilot light operates all the time and the gas furnace has a device to verify that the pilot light is lit. This one covers how to light the pilot on the gas furnace. Strike up your match or lighter. This video is part of the heating and cooling series of training videos made to accompany my web.

When the heat kicks on the system blows cold air so we believe the pilot light is out. The system has a knob with markings that read off and on but there s no pilot marking which is commonly found on these things. Turn off the furnace fireplace or water heater before you begin work. The thermocouple generates a small electrical voltage when it is hot.

I have an old lennox duraglass gii furnace in the house i recently moved into. Locate the switch and turn it all the way to the off position. The device used is called a thermocouple. Keep the knob in for 20 seconds and then release it and turn it to the on position.

Switch pilot light to off there will either be a pilot on or off button near the bottom of your furnace. If your old gas furnace has a standing pilot you can follow a standard procedure to relight the pilot light.