How To Make Log Bench Legs

Read through to learn some economical ways to make log benches.

How to make log bench legs.

Use the chainsaw to cut a chunk out of the log along that line measuring 4 inches deep 4 inches wide and 8 inches long along the line. I also put in leg braces by grinding down the ends of braces to 0 75 and glueing them in with gorilla glue. How to make a quality log bench out of only a log and a chainsaw. Drill a few holes into whatever lumber you have to accept the legs insert the legs apply some glue and voila you have just finished your first rustic furniture piece.

Place a 1 1 2 inch wide straightedge on the flat surface on edge against one of the legs. Using tree logs you can build classy wooden seats without burning a hole in the pocket. Split the other half of the log a little larger than 2 inches by 2 inches to make the legs. For a best fit the holes must not be straight but angled at 10 degrees from vertical away from the axis of the bench.

For an adult bench you can cut them about 24 inches long but they can be much shorter for a child s bench or footstool. Place one of the legs in front of you with the smooth side facing up. Specially cut grooves lock in and hold the bench together. Mark four places for the legs.

Logs connected in a triangle. Repeat this process on the second leg. If you want to make two benches you can use both halves of the large log for the two tops and cut the legs from smaller branches. Drill the holes approximately 3 inches deep until you ensure that the legs fit in snugly in the bench top.

Stand the bench on its legs on a flat surface. If you then also had spars or stretchers connected firmly to each of the legs 3 seems like a good number that would make it harder for the table to topple. Draw a straight line across the center of the flat surface of the log. It doesn t take but seconds to cut the tenons when using lumberjack s tenon cutters.

No hardware or tools needed. A sturdy bench is one of the most versatile furniture you need either in the backyard or home for providing additional seating for guests and family members. I made a mixture of sawdust elmer s glue packed it into any void between legs bench. Within an hour or two you can make these tables less if you have the logs lying around.

Trace the line of the straightedge across the leg transferring the angle of the flat surface to the leg. Position the bench top on a flat surface.