How To Clean Ceramic Tile Floors After Installation

Dampen the sponge with the solution and scrub the tiles.

How to clean ceramic tile floors after installation.

Wipe the tiles using a soft cloth dipped in the vinegar mixture. Dab a small amount of the solution onto a clean damp sponge or directly to the tiles according to manufacturer s instructions. This can help push the grout haze into the spaces between the tiles. First try removing the grout haze with your grout sponge and water.

Use a bit of force to remove the cloudy haze from the tile. Mix equal parts of vinegar and water in a bucket. Rub the solution over the tiles to remove the residue. 2 wipe along the edges of the grout lines rinsing the sponge between.

Scrub mold or mildew with soap and water. There should be no need to use stronger stuff but if you. Wipe the tiles using a circular motion to remove as much of the grout as possible. If that doesn t work while still wet get your grout float and slide over the area.

Once you ve grouted the new tiles you ll also need to clean leftover traces. Don t press the tiles until the adhesive mortar is completely dry. Wait until the seal begins to take before cleaning the surplus. To use vinegar on porcelain or ceramic mix four parts water with one part white vinegar.

Run a dry cloth over the tiles to remove any leftover and dry the floor. Once the tile has been laid it is only necessary to wait until the adhesive and grout has dried or cured before use. Scrub the floor with a nylon or natural bristle brush. Add white distilled vinegar to the water if plain water was ineffective.

Fill a bucket with warm water and a couple of drops of dish soap. Rinse the sponge in the bucket as needed. Wash the tiles again with plain water to remove any remaining vinegar. This takes between three days and one week depending on the company of adhesive and grout used.

After sweeping or vacuuming mop ceramic tile floors at least once a week with a small amount of mild dish detergent mixed in hot water.