How To Cut Laminate Flooring With Miter Saw

Always use a fine tooth and have the saw rolling before you touch the boards.

How to cut laminate flooring with miter saw.

Plunge the saw blade into the laminate flooring. Test the direction of the teeth on your saw blade. The jigsaw will be much slower than a circular saw or miter saw though so keep this in mind and it will usually burn through a good amount of blades. You can perfectly well saw your laminate floorboards with a regular hand saw.

In order to get accurate cuts clamp the straight edge or a laminate flooring plank to your board making sure the blade of the jigsaw goes exactly over the cut line at both sides. This is ideal because it can do a 90 degree cut. When it comes to cutting the laminate flooring using a miter saw you just need to be careful to protect the material as well as your body. In addition a dull blade might lead to the motor on the saw burning out as it struggles to get the blade through the wood.

Let go of the blade guard and allow it to snap into place. This way you know if you have to saw up or down with the decor to obtain a nice saw cut. Wear goggles a dust mask and gloves. Like board flooring tile should be shaped in straight lines using the proper safety equipment.

What you need is to create the cut marks properly and leave the rest to your miter saw. Just made a mark and the miter saw will take the rest of the work. Cutting laminate flooring with a miter saw is so simple. The dense resin binder and wood mix in laminate flooring will quickly dull standard blades.

You can use a circular saw miter saw or table saw for the work but you should buy a carbide tipped blade. Use a utility knife to make long incisions instead of a saw. How to cut laminate tile. Place the laminate flooring board on a sturdy surface saw horse and lock it into position with several c clamps or with the help of a friend.

Cut along the chalk line beginning at one end of the line and ending at the other end of the line. Use a pencil or chalk to mark where the line you want to separate the board. Place the tile on a stand or hold it steady with clamps. But 50 degrees can cut by most of the miter saws.

In fact using a miter saw is simple.