How To Fix Sliding Door

If the rollers are damaged install replacement rollers available at home centers.

How to fix sliding door.

In some cases you may be able to clean out the rust and re adjust the rollers but usually you will need to go ahead and replace both. Insert a flathead screwdriver into each hole and turn the screw counterclockwise all the way. This retracts the rollers lowering the door. To clean and lubricate the hardware of a sliding closet door use a stiff brush a toothbrush or a hand vacuum to clean dust from the tracks.

To install lift the top of the door into the rear track guide at a slight angle and then tilt the bottom into place. Lay a drop cloth on the floor and pop off the two plugs covering the roller adjustment screws at the bottom of the sliding door frame. Reattach the head stop first otherwise it could fall out. Be careful sliding doors can be very heavy.

Use an aerosol lubricant to lubricate all the door rollers. Parts for these doors are readily available at home centers hardware stores or online. If you have a sliding closet door that glides on a bottom track clean the track with a damp cloth to ensure smooth gliding. Scrub caked dirt and grime out of the track with a stiff brush and soapy water.

You may also want to check out our step by step guide to adjusting your sliding doors. Then sharply angle the bottom of the door outward and lift the door from the track. Start with a good cleaning. Lift a bottom supported door such as an sliding glass patio door straight up to clear the bottom track.

Step 2 to adjust the door you ll need the thin offset spanner supplied with the door. Sliding door rollers replacement we recommend placing the door up on a support frame or a pair of sawhorses while you work on fixing or replacing the roller assemblies. Roll the door toward the latch side jamb then turn the adjustment screws until the door is parallel with the jamb. Sliding glass door repair will get the job done.

On the opposite side a guide pin slides through a top channel. Align it in the bottom track and then tilt it up. These are sometimes located in the edges of the door. Look for the door manufacturer s name on the edge of the door or the hardware manufacturer s name on the roller.

Fit the rear sliding door. Since the doors will overlap slightly you will need to fit the rear door before the front door. If the door still doesn t slide smoothly the rollers under the door either need adjusting or are shot. Bifold doors are anchored at the bottom and top of one side.

You can order rollers and other door parts for repairing sliding doors through lumberyards and home centers or online. Note that some sliders have a removable molding at the top that is designed to prevent the door from falling out. Step 1 to remove the pelmet that hides the door rollers first run a sharp knife along the join between pelmet and door frame to cut the paint.