Each aluminum porch railing will be six feet in length and there will be a post between each piece.
How to install aluminum porch railing on concrete.
Thread the bolts through the anchor plates and into the sleeves.
Wrap the aluminum outer post completely around it.
How to install railing on concrete porch standard plans lumber and your home and wood or cut a level.
If you are installing in cold weather leave a 3 16 expansion gap for the railing to expand with a change of temperature.
Line up the holes that are in the anchor plates with the ones you have drilled into the concrete base.
2 mark the concrete at.
Locating and drilling the holes 1 find the exact center of the post location.
As some may need to be cut to fit the figure in an extra piece.
To install your metal railings stand them up section by section.
Align the outer edges of each post base 1 inch from the edge of the concrete stairs or landing.
Make sure you insert every single one of your balusters and make sure they are secure by pressing down on them tightly.
Aluminum porch railing bolt the floor flange first into the concrete at the bottom of the canopy or from the desired starting point.
Lay the bracket on the concrete and mark the center point of the bolt hole with a carpenter s pencil keeping the.
Ask this old house mason mark mccullough installs a custom metal railing using anchoring cement subscribe to this old house.
Align the upper end of the railing at the face of the house or a porch post.
Tighten them with the use of a wrench.
Aug 2 20 8 harmony railing aluminum stair railing installation.
5 964 views 5k how to anchor a steel handrail to concrete steps.
Diy wooden porch handrail ideas wood freedom aluminum railing installation black aluminum handrails installed on how to install railing with base plates vinyl railing attached to concrete aluminum railing parts mounts for.
Then install your next support post and get it attached to the base rail for your balusters.
Use recommended bit size with concrete anchors and vacuum up the dust from the anchor holes.
Cut your railing couple inches longer and mark on the spot instead of trying to cut to the exact size.