How To Install Door Stopper On Hinge

Slide the pin back through the door stop hole and the hinge.

How to install door stopper on hinge.

Insert the hinge pin into the hole in the stopper assembly from above so that the shank of the pin extends below the assembly. Tap the hinge pin s back in and adjust the desired travel of the door not less than 90 degrees by turning the threaded set screw in or out. Step 3 adjustments. At first close the door completely and slide the tip of the screwdriver under the head of the hinge.

Place the tip of the screwdriver underneath the flared top of the hinge pin and use the screwdriver as a lever to force it out. If you you have a door that is swinging and hitting a wall or other objects in your room there is an easy way to control how far the door can open. Pry the top hinge pin out. A set of hinge pin door stops.

This leaves the stopper assembly. The doors are heavier. A door that opens too wide can damage your walls. Take a pencil and mark 1 5 inches inward on the door and the wall.

After that tap the screwdriver gently to lever the pin up to the point. Installing a hinge pin door stop is an easy and inexpensive way to correct this. If you re putting on on an exterior door you should add at least two door stops. Install the doorstop over the hinge then reinstall the pin.

Close the door on which you are installing the stop and use a flat head screwdriver to pry the hinge pin out of the top hinge. The hinge pin door stop will be an alternative pin which will install in place of the original pin and have the door stop attached to it. Note the direction that the hinge pin is facing the flat part is against the door the round part hits the molding. One that s 1 5 inches inward on the door and one that s straight across on the wall when they re held parallel.

You should have two dots. For heavy doors install another doorstop in the bottom hinge. The best way to do this is to put the stopper between the door and the wall and hold it so the stopper is flat on both sides. Then gaze the hinge pin up and remove it.

Close the door then use an old straight slot screwdriver to gently pry up and remove the top hinge pin. Tap it back in with your hammer. Slide the pin back into the hinge. Watch our video for more i.