Screw the ipe deck boards so they hold firm to the joist.
How to install ipe wood decking.
Hand nailing ipe will cause the wood to split.
Some shrinking will occur as the wood dries.
This also allows for proper air circulation.
Use 305 or 316 grade stainless steel deck screws.
The approximate shrinkage is 1 16 1 8 on 3 wide deck boards.
Ipe must be kept dry until it s installed.
With the ipe clip fastener system no screws or holes show from the surface.
This will allow the ipe plug to blend into the board.
Next sand the board and oil it.
The difference in gap spacing is to ensure that the decking has room to expand and contract depending on the material used and the environment where it is installed.
These trap water and moisture and can create stability issues.
Countersink 3 8 holes into face of deck boards.
Cover ipe wood with plywood during the acclimation process.
When installing ipe decking be sure to leave a gap between deck boards of 3 32.
Then with a mallet tap the ipe plugs as far as possible into the deck.
Ipe decking installation instructions tips.
Do not cover the ipe lumber with any tarp or any plastic.
Also applies to garapa cumaru.
Deck boards should be installed with slight spacing for drainage a penny may be used as a guide for spacing between boards.
3 8 deck plugs are available in a number of hardwood varieties.
Main menu wood decking ipe decking cumaru decking tigerwood decking brazilian teak decking garapa decking massaranduba decking itauba decking cypress decking deck tiles dock decking trailer decking fencing odd sizes fsc decking clearance items.
Predrill 1 8 pilot holes completely through the deck boards.
The ipe clip fasteners are fiberglass reinforced so that they are one of the strongest ways to fasten ipe decking.
To use an ipe plug first drive the screw is into the board after which you dab a bit of wood glue over the screw and place an ipe plug in the hole.
Face screw plug method.
1 8 1 4 on 5 wide deck boards.
When installing hidden fasteners angle the screw through the fastener through the deck board and into the joist.
Use wood plugs to fill the holes.