How To Program Clicker Keypad To Genie Garage Door Opener

Super easy to do.

How to program clicker keypad to genie garage door opener.

Use a universal keypad if you don t know what type to get. Press the button once a second until the door responds and your keypad will be programmed and ready for use. To reboot your whole system turn off and unplug your garage door opener. Open the remote by sliding the battery cover open.

On the remote control select the button you want to program press and release that button on the remote 6 times making sure that the led light stops flashing between each press. Press the button and hold it until the smart led indicator light on the receiver unit flashes. Locate the smart button and corresponding indicator led light on your garage door opener s panel unit. Program to a genie overhead garage door opener with intellicode.

Once it s unplugged wait approximately 5 minutes and then plug your garage door opener back in again. On the clicker keypad enter the pin from step 1 and press and release the 0 key. Enter the pin number that you just created on the keypad and press the send button on your remote four times. If you re still having problems with the keypad on your garage door remote controller then you might want to think about doing a complete reboot.

Do it yourself garage door repair clic. On the clicker keypad enter the pin from step 1 and press and release the 0 key. Both leds on the garage door opener will light up purple. Programming the clicker universal remote to a garage door opener receiver with learn button.

Step 2 choose a button on the remote control to control your garage door. This will activate the garage door opener and programming is complete. On the clicker keypad press and release 0 again. Press the selected button on your remote control 3 times.

They program to most makes and models. Both leds on the garage door opener will light up purple. Start with the garage door closed. On the clicker keypad press and release 0 again.